5-minute toolbox talk

Hand and power tools: guards on, cords right

Updated

Why it matters: Tools make the work possible, but a missing guard, a bad cord or the wrong tool for the job causes serious cuts, amputations, shocks and eye injuries.1

Hand and power tools: guards on, cords right

Before you start

Pass around one tool with a bad cord or a missing guard, and have the crew spot the problem. Read the key points out loud, then let the crew answer the questions. It takes about five minutes.

Key points

  • Inspect the tool before you use it. Tag out anything with a damaged cord, a missing guard or a cracked housing.
  • Keep guards in place and working. Never pin back a saw guard.
  • Unplug or remove the battery before you change blades, bits or accessories.
  • Wear safety glasses, goggles or a face shield when the tool can throw particles.
  • Never carry a tool by its cord or yank the cord to unplug it.
  • If you clean with compressed air, keep it at 30 psi or less, use it with guarding and PPE, and never use it to blow off your clothes.

On your crew

  • Landscaping: Chainsaws, string trimmers and cut-off saws throw debris and kick back. Keep the chain brake and guards working, and wear eye, face and hearing protection.
  • Welding: An angle grinder spins fast enough to throw a broken disc. Use the right disc for the speed of the grinder, keep the guard on, and unplug it before changing the disc.
  • Plumbing and pipefitting: Pipe threaders, press tools and reciprocating saws carry a lot of torque. Brace the work, keep your hands clear of the cut line, and use the support legs on the threader.
  • Electrician: Corded tools on wet or outdoor jobs need ground-fault protection. Check the cord and plug every time, and replace damaged cords instead of taping them.

Talk it over

  1. Which tool on this job gets used without its guard, and why?
  2. What is the right tool for the cut we keep doing the hard way?

On the job

OSHA's struck-by guidance covers tools too: use eye or face protection where machines and tools can throw particles, and inspect saws and similar tools to make sure their guards are in good shape.12

Free printable sign-in sheet

Fill in the top on your phone or by hand, then print. The talk prints first, and the sign-in sheet starts on its own page.

Toolbox talk sign-in sheet

#Printed nameSignature
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

By signing, each worker confirms they attended this talk. Keep this sheet with your job records.

A fresh talk for your crew

Founding employers on the Tough and Dirty crew board get a new toolbox talk every Monday, with the sign-in sheet ready to print.

Get a new talk every Monday in your crew dashboard

Next talk

Housekeeping: clear paths, clean site · All 12 toolbox talks

Sources

  1. OSHA: Hand and Power Tools, checked Nov 19, 2026
  2. OSHA Construction eTool: Struck-By Hazards, checked Nov 19, 2026

Estimates, not promises. Rules change; check with the employer and the agency.