5-minute toolbox talk

Housekeeping: clear paths, clean site

Updated

Why it matters: Scrap, cords and debris in walkways cause slips, trips, punctures and fires. A clean site is a faster site, and it shows the crew takes the work seriously.1

Housekeeping: clear paths, clean site

Before you start

Walk the site as a crew before the talk, and pick the three worst spots to clean up before work starts. Read the key points out loud, then let the crew answer the questions. It takes about five minutes.

Key points

  • Keep scrap lumber with nails sticking out, and all other debris, out of work areas, walkways and stairs.
  • Bend over or pull nails as you strip forms, so nobody steps on them.
  • Haul combustible scrap off regularly, not just at the end of the job.
  • Use the containers on site for trash, oily rags and other waste, and keep each kind where it belongs.
  • Route cords and hoses out of walkways, and clean up spills when they happen.
  • Leave your area cleaner than you found it at every break and at the end of the shift.

On your crew

  • Welding: Hot slag and sparks plus scrap, rags and cardboard start fires. Clear combustibles from the work area before you strike an arc, and keep a fire extinguisher close.
  • Roofing: Old shingles, nails and wrappers on the roof and the ground cause slips and punctures. Chute debris straight into the dumpster, and sweep the ground around the work at breaks.
  • Millwright: Oil, grease and parts on the plant floor are slip hazards. Clean spills when they happen, and stage tools and parts off the walkways.
  • Septic and sewer: Hoses, fittings and mud around the truck and the tank are trip hazards. Coil the hose when it is not pumping, and keep a clear path between the truck and the tank.

Talk it over

  1. Where is the worst trip hazard on this job right now?
  2. Who owns cleanup in each area today?

On the job

OSHA's construction housekeeping rule, 29 CFR 1926.25, requires that form and scrap lumber with protruding nails and all other debris be kept clear of work areas, passageways and stairs.12

Free printable sign-in sheet

Fill in the top on your phone or by hand, then print. The talk prints first, and the sign-in sheet starts on its own page.

Toolbox talk sign-in sheet

#Printed nameSignature
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

By signing, each worker confirms they attended this talk. Keep this sheet with your job records.

A fresh talk for your crew

Founding employers on the Tough and Dirty crew board get a new toolbox talk every Monday, with the sign-in sheet ready to print.

Get a new talk every Monday in your crew dashboard

Next talk

Heat stress: water, rest, shade · All 12 toolbox talks

Sources

  1. OSHA 29 CFR 1926.25, Housekeeping, checked Nov 19, 2026
  2. OSHA: Walking-Working Surfaces, checked Nov 19, 2026

Estimates, not promises. Rules change; check with the employer and the agency.