5-minute toolbox talk

Ladders: set it right, climb it right

Updated

Why it matters: Ladders are on almost every job, which is exactly why people get careless with them. A ladder at the wrong angle, on a slick spot, or with a bad rail can put you on the ground in a second.1

Ladders: set it right, climb it right

Before you start

Bring a real extension ladder to the talk and set it up together, checking the angle and the 3-foot extension above the landing. Read the key points out loud, then let the crew answer the questions. It takes about five minutes.

Key points

  • Set extension ladders at about a 4-to-1 angle: the foot about one quarter of the working length out from the top support.
  • When you use a ladder to reach a roof or landing, the rails must stick up at least 3 feet above it, or the top has to be tied off.
  • Only set ladders on stable, level ground. On slick surfaces, secure the ladder or use slip-resistant feet.
  • Face the ladder going up and down, keep at least one hand on it, and do not carry loads that throw off your balance.
  • Never stand on the top step of a stepladder, and do not climb the back cross-bracing.
  • Near live electrical equipment, use a ladder with nonconductive side rails. Tag out any ladder with a broken rail or rung and take it off the job.

On your crew

  • Electrician: Use fiberglass ladders with nonconductive rails near panels, service drops and overhead conductors. An aluminum ladder near energized equipment is a shock path.
  • HVAC: Rooftop units mean climbing with gauges, tools and parts. Hoist the bag or use a tool lanyard and rope so both hands and the climb stay free.
  • Roofing: Tie off the top of the ladder at the eave, and keep the rails 3 feet above it so there is something to hold onto when stepping on and off the roof.
  • Plumbing and pipefitting: Stepladders get used for overhead pipe and hangers. Pick one tall enough that you are not standing on the top step or top cap to reach the work.

Talk it over

  1. Which ladder on this job would you not trust right now, and why?
  2. Where do we need to carry tools up a ladder, and how can we get them up without carrying them in our hands?

On the job

OSHA's construction ladder rule requires a competent person to inspect ladders for visible defects on a regular basis and after anything that could affect safe use, such as a drop or a strike from equipment.12

Free printable sign-in sheet

Fill in the top on your phone or by hand, then print. The talk prints first, and the sign-in sheet starts on its own page.

Toolbox talk sign-in sheet

#Printed nameSignature
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

By signing, each worker confirms they attended this talk. Keep this sheet with your job records.

A fresh talk for your crew

Founding employers on the Tough and Dirty crew board get a new toolbox talk every Monday, with the sign-in sheet ready to print.

Get a new talk every Monday in your crew dashboard

Next talk

Trenching: slope it, shore it, shield it · All 12 toolbox talks

Sources

  1. OSHA 29 CFR 1926.1053, Ladders, checked Nov 19, 2026
  2. OSHA: Fall Prevention Campaign, checked Nov 19, 2026

Estimates, not promises. Rules change; check with the employer and the agency.