5-minute toolbox talk

Fall protection: plan, provide, train

Updated

Why it matters: Falls kill more construction workers than anything else. Six feet is the line: at 6 feet or more above a lower level, you need fall protection.1

Fall protection: plan, provide, train

Before you start

Hold the talk where the fall hazard is: under the roof edge, the open floor or the scaffold you will be on today. Read the key points out loud, then let the crew answer the questions. It takes about five minutes.

Key points

  • Plan the job before you go up: list every edge, hole, skylight and leading edge, and pick the fall protection for each one.
  • If you tie off, every worker who needs it gets their own harness, it fits, and it is inspected before use.
  • Anchor only to something rated for it. A harness is only as good as what it is tied to.
  • Cover and mark holes and skylights so nobody steps through them.
  • Use the right ladder or scaffold for the task instead of making do with what is on the truck.

On your crew

  • Roofing: Leading edges, skylights and roof openings are the classic hazards. Pick the anchor point before the first bundle goes up, and cover and mark every skylight.
  • Linework: Climbing poles and working from buckets each call for their own fall protection. Check the harness, lanyard and connection to the boom or pole every time, not just at the start of the week.
  • Millwright: Setting equipment on mezzanines, platforms and open steel puts people near unguarded edges. Rig the guardrails or tie-off points before the lift starts, not after.
  • HVAC: Rooftop work near the roof edge or near openings for new curbs needs the same planning as roofing. A unit swap is not too short to skip it.

Talk it over

  1. Where on this job could someone fall 6 feet or more?
  2. What is each of us tied to up there, and who checked it?

On the job

OSHA's Fall Prevention Campaign cites BLS data: in 2024 there were 389 fatal falls to a lower level out of 1,034 construction deaths.12

Free printable sign-in sheet

Fill in the top on your phone or by hand, then print. The talk prints first, and the sign-in sheet starts on its own page.

Toolbox talk sign-in sheet

#Printed nameSignature
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

By signing, each worker confirms they attended this talk. Keep this sheet with your job records.

A fresh talk for your crew

Founding employers on the Tough and Dirty crew board get a new toolbox talk every Monday, with the sign-in sheet ready to print.

Get a new talk every Monday in your crew dashboard

Next talk

PPE: the right gear, worn right · All 12 toolbox talks

Sources

  1. OSHA: Fall Prevention Campaign (Plan. Provide. Train.), checked Nov 19, 2026
  2. OSHA: Fall Protection, checked Nov 19, 2026

Estimates, not promises. Rules change; check with the employer and the agency.